Chemical mold and form-work release agent
Vetorel XT421 is a single component, low viscosity pale straw colored liquid composed of synthetic mineral oils and special varied additives that performs in a superior manner to standard oil based mold release agents. Vetorel XT421 provides the plywood surface with a water repellent film preventing concrete from adhering to the form work resulting with a smooth, stainless concrete surface.
Concrete Society Category 5 chemical mold release agent.
Vetorel XT421 supplied in 20 & 200 Ltr. Coverage - 20 - 60 m2/Ltr.
Original sealed container of Vetorel XT421 and has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 35ºC.
Vetorel XT421 is supplied in pails or drums ready to use at site without a need to premix operation. It can be applied by brush, roller or spraying machine.
Apply Vetorel XT421 on plywood or steel shutter before the first casting. After every use of form-work, the shutter should be recoated lightly with Vetorel XT421
Do not over apply Vetorel XT421 on the form-work. Excessive material should be allowed to drain before using the form-work.
Apply the product with a brush or preferably with a sprayer. For best results, it is advisable to apply Vetorel XT421 at least two hours before using the shutter.
Consult Saveto technical department for any additional information.
All molds, shutter surfaces must be cleaned from deposits of rust, concrete, oil or other materials. The product is ready to use without any dilution.
Vetorel XT421 contains hydrocarbon oils and should be treated as potentially harmful as there is a possible risk of irreversible effects in contact with skin. Vetorel XT421 should not be swallowed or allowed to come into contact with skin and eyes. Avoid inhalation of vapors and ensure adequate ventilation.
Wear suitable gloves and eye/face protection. Should accidental skin contact occur, remove immediately with soap and water - do not use solvent.
In case of contact with eyes rinse immediately with plenty of water and seek medical advice, if swallowed seek medical attention immediately - do not induce vomiting.
For further information consult the Material Safety Data sheet available for this product.
Vetorel XT421 has a shelf flash point, so the flammability risk is low. Do not expose to naked flames or other sources of ignition.
Flash point: above 60ºC.
Cleaning and disposal
Spillages of Vetorel XT421 should be absorbed onto sand, earth or vermiculite and transferred to suitable containers. Contaminated areas will become slippery.
The disposal of excess or waste material should be carried out in accordance with local legislation under the guidance of the local waste regulatory authority.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Epoxy resin twin cartridge anchoring grout
Water based concrete curing compound
Resinous, render receiving concrete curing compound
Water based acrylic curing compound and primer
Multipurpose universal cementitious non-shrink grout
Elastomeric, pigmented acrylic, anti-chloride ion and carbonation protective and decorative coating for concrete and masonry